LTC1876 - High Efficiency, 2-Phase, Dual Synchronous Step-Down Switching Controller and Step-Up Regulator

The LTC®1876 is a high performance triple output switching regulator. It incorporates a dual step-down switching controller that drives all N-channel synchronous power MOSFET stages. A step-up regulator with an internal 1A, 36V switch provides the third output.

The step-down controllers minimize power loss and noise by operating the output stage of each controller out of phase. OPTI-LOOP compensation allows the transient response to be optimized over a wide range of output capacitance and ESR values. A RUN/SS pin for each controller provides both soft-start and an optional timed, short-circuit shutdown that can be configured to latch offone or both controllers. Current foldback provides additional short-circuit protection. In an overvoltage condition, the bottom MOSFET is latched on until VOUT returns to normal. The FCB pin can be used to inhibit Burst Mode operation or to enable regulation of a secondary output voltage.

The step-up regulator operates at 1.2MHz, allowing the use of tiny low cost capacitors and inductors. In addition,its internal 1A switch allows high current outputs to be generated. Its current mode control scheme provides excellent line and load regulation.

特点
  • Step-Down Controller
  • Out-of-Phase Controllers Reduce Required Input Capacitance and Power Supply Induced Noise
  • Power Good Output Voltage Indicator
  • OPTI-LOOP™ Compensation Minimizes COUT
  • DC Programmed Fixed Frequency 150kHz to 300kHz
  • Wide VIN Range: 3.5V to 36V Operation
  • Very Low Dropout Operation: 99% Duty Cycle
  • Adjustable Soft-Start Current Ramping
  • Latched Short-Circuit Shutdown with Defeat Option
  • Remote Output Voltage Sense and OV Protection
  • 5V and 3.3V Standby Regulators
  • Selectable Const. Freq. or Burst Mode™ Operation
  • Step-Up Regulator
  • High Operating Switching Frequency of 1.2MHz
  • Low Internal VCESAT Switch: 400mV @ 1A, VIN = 3V
  • Wide VIN Range: 2.6V to 16V Operation
  • High Output Voltage: Up to 34V
典型应用
LTC1876 Typical Application
应用
  • 3.3V Input Step-Down Converter
  • Notebook and Palmtop Computers, PDAs
  • Battery-Operated Digital Devices
封装信息
LTC1876 Package Drawing
Order Information 订购型号
器件型号封装温度价格 (以 1 ~ 99 片为批量)价格 (以 1000 片为批量) *
LTC1876EG#PBFSSOP-36E$7.04$5.95
LTC1876EG#TRPBFSSOP-36E$6.05
演示电路板
器件型号描述价格
DC324ALTC1876EG | High Efficiency, Low Cost 3-Output Power Supply, 7.5~24Vin, Outputs = 3.3V/5A, 5V/5A, 12V/0.2A$150.00
DC386ALTC1876EG | Dual-Phase High Efficiency 3 Output Power Supply, 3.3V~3.6Vin, 2.5V/15A, 1.8V/15A, and 5V/100mA联系凌力尔特
数据表
设计要点
可靠性数据
LT Journal
CAD 符号
相关产品
LTC1876 - High Efficiency, 2-Phase, Dual Synchronous Step-Down Switching Controller and Step-Up Regulator
Design Solutions 10 - Active Voltage Positioning Reduces Output Capacitors
DN278 - Efficient DC/DC Converter Provides Two 15A Outputs from a 3.3V Backplane
R384 Reliability Data
May 2002 Efficient DC/DC Converter Provides Two 15A Outputs from a 3.3V Backplane
Nov 2000 Triple, High Output Current Supply Requires only 3.3V Input and Minimal Input Capacitance
LTC1876 Footprints and Symbols