MC100H646: PECL/TTL-TTL 1:8 Distribution Chip
The MC10H/100H646 is a single supply, low skew translating 1:8 clock driver. Devices in the H600 translator series utilize the 28-lead PLCC for optimal power pinning, signal flow through and electrical performance. The single supply H646 is similar to the H643, which is a dual supply 1:8 version of the same function. The H646 was designed specifically to drive series terminated transmission lines. Special techniques were used to match the HIGH and LOW output impedances to about 7ohms. This simplifies the choice of the termination resistor for series terminated applications. To match the HIGH and LOW output impedances, it was necessary to remove the standard IOS limiting resistor. As a result, the user should take care in preventing an output short to ground as the part will be permanently damaged. The H646 device meets all of the requirements for driving the 60 and 66MHz Pentium Microprocessor components, which greatly simplifies its implementation into a digital design. The eight copies of the clock allows for point-to-point clock distribution to simplify board layout and optimize signal integrity. The H646 provides differential PECL inputs for picking up LOW skew PECL clocks from the backplane and distributing it to TTL loads on a daughter board. When used in conjunction with the MC10/100E11 designed. In addition, a TTL level clock input is provided for flexibility. Note that only one of the inputs can be used on a single chip. For correct operation, the unused input pins should be left open. The Output Enable pin forces the outputs into a high impedance state when a logic 0 is applied. The output buffers of the H646 can drive two series terminated, 50 transmission lines each. This capability allows the to drive up to 16 different point-to-point clock loads. Refer to the Applications section for a more detailed discussion in this area. The 10H version is compatible with MECL 10H ECL logic levels. The 100H
特性- PECL/TTL-TTL Version of Popular ECLinPS E111
- Low Skew
- Guaranteed Skew Spec
- Tri-State Enable
- Differential Internal Design
- VBB Output
- Single Supply
- Extra TTL and ECL Power/Ground Pins
- Matched High and Low Output Impedance
- Meets Specifications Required to Drive the Pentium Microprocessor
- Pb-Free Packages are Available
|
封装
应用注释 (14)
数据表 (1)
仿真模型 (1)
封装图纸 (1)
Document Title | Document ID/Size | Revision |
---|
28 LEAD PLCC | 776-02 (67.7kB) | F |
产品订购型号
产品 | 状况 | Compliance | 封装 | MSL* | 容器 | 预算价格 (1千个数量的单价) |
---|
MC100H646FNG | Active | Pb-free
Halide free | PLCC-28 | 776-02 | 3 | Tube | 37 | 联系BDTIC |
订购产品技术参数
Product | Type | Channels | Input / Output Ratio | Input Level | Output Level | VCC Typ (V) | tJitterRMS Typ (ps) | tskew(o-o) Max (ps) | tpd Typ (ns) | tR & tF Max (ps) | fmaxClock Typ (MHz) | fmaxData Typ (Mbps) |
---|
MC100H646FNG | Buffer | 1 | 2:1:8 | ECL | TTL | 5 | | 350
500 | 5.35
4.9 | 1500 | 80 | |