/******************** (C) COPYRIGHT 2007 STMicroelectronics ********************
* File Name          : Readme.txt
* Author             : MCD Application Team
* Version            : V4.0
* Date               : 10/09/2007
* Description        : Description of the UART interrupt Example.
********************************************************************************
* THE PRESENT SOFTWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS
* WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE TIME.
* AS A RESULT, STMICROELECTRONICS SHALL NOT BE HELD LIABLE FOR ANY DIRECT,
* INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM THE
* CONTENT OF SUCH SOFTWARE AND/OR THE USE MADE BY CUSTOMERS OF THE CODING
* INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS.
*******************************************************************************/

Example description
===================
This example shows how to use the UART in order to communicate between the 
STR71x and a PC using RS232 protocol.
The main program configures the UART0 to generate an interrupt after a byte
reception. The received byte will be read in the UART0 interrupt service routine
to be transmitted back to the Host PC.
The communication is performed using the Hyperterminal application under 
Windows.

Press any key , you will see the same character in the Hyperterminal 
application window. If you stop the program execution,the characters won't 
be displayed.


Directory contents
==================
 71x_conf.h  Library Configuration file
 71x_it.c    Interrupt handlers
 71x_it.h    Interrupt handlers header file
 main.c      Main program
 
   
Hardware environment
====================
Connect the COM A port on the STR71x-Eval board (mb393) using a serial link to a PC
- Hyperterminal configuration:
    - Word Length = 8 Bits
    - 1 Stop Bit
    - No parity
    - BaudRate = 9600 baud
    - flow control: None  


How to use it
=============
In order to make the program work, you must do the following :
- Create a project and setup all your toolchain's start-up files
- Compile the directory content files and required Library files :
  + 71x_lib.c
  + 71x_apb.c
  + 71x_eic.c
  + 71x_gpio.c
  + 71x_rccu.c
  + 71x_uart.c
  
- Link all compiled files and load your image into either RAM or FLASH
- Run the example


******************* (C) COPYRIGHT 2007 STMicroelectronics *****END OF FILE****
