PCA9517A: Level translating I²C-bus repeater

The PCA9517A is a CMOS integrated circuit that provides level shifting between low voltage (down to 0.9 V) and higher voltage (2.7 V to 5.5 V) I²C-bus or SMBus applications. While retaining all the operating modes and features of the I²C-bus system during the level shifts, it also permits extension of the I²C-bus by providing bidirectional buffering for both the data (SDA) and the clock (SCL) lines, thus enabling two buses of 400 pF. Using the PCA9517A enables the system designer to isolate two halves of a bus for both voltage and capacitance. The SDA and SCL pins are overvoltage tolerant and are high-impedance when the PCA9517A is unpowered.

The 2.7 V to 5.5 V bus port B drivers behave much like the drivers on the PCA9515A device, while the adjustable voltage bus port A drivers drive more current and eliminate the static offset voltage. This results in a LOW on the port B translating into a nearly 0 V LOW on the port A which accommodates smaller voltage swings of lower voltage logic.

The static offset design of the port B PCA9517A I/O drivers prevent them from being connected to another device that has rise time accelerator including the PCA9510, PCA9511, PCA9512, PCA9513, PCA9514, PCA9515A, PCA9516A, PCA9517A (port B), or PCA9518. Port A of two or more PCA9517As can be connected together, however, to allow a star topography with port A on the common bus, and port A can be connected directly to any other buffer with static or dynamic offset voltage. Multiple PCA9517As can be connected in series, port A to port B, with no build-up in offset voltage with only time of flight delays to consider.

The PCA9517A drivers are not enabled unless VCC(A) is above 0.8 V and VCC(B) is above 2.5 V. The EN pin can also be used to turn the drivers on and off under system control. Caution should be observed to only change the state of the enable pin when the bus is idle.

The output pull-down on the port B internal buffer LOW is set for approximately 0.5 V, while the input threshold of the internal buffer is set about 70 mV lower (0.43 V). When the port B I/O is driven LOW internally, the LOW is not recognized as a LOW by the input. This prevents a lock-up condition from occurring. The output pull-down on port A drives a hard LOW and the input level is set at 0.3VCC(A) to accommodate the need for a lower LOW level in systems where the low voltage side supply voltage is as low as 0.9 V.

Parameter

PCA9517[1]

PCA9517A[2]

electrostatic discharge, HBM

> 2 kV

> 5.5 kV

[1] PCA9517 will be discontinued in several years, so move to the PCA9517A for all new designs and system updates.

[2] The PCA9517A is an improved hot swap and ESD version of the PCA9517, but otherwise operates identically and should be used for all new designs and system updates.

PCA9517A: Product Block Diagram
sot1069-2_3d
Data Sheets (1)
Name/DescriptionModified Date
Level translating I2C-bus repeater (REV 4.1) PDF (378.0 kB) PCA9517A24 May 2016
Application Notes (2)
Name/DescriptionModified Date
Level shifting techniques in I2C-bus design (REV 1.0) PDF (52.0 kB) AN1044120 Jun 2007
I2C / SMBus Repeaters, Hubs and Expanders (REV 2.0) PDF (1.0 MB) AN25519 Dec 2002
Users Guides (4)
Name/DescriptionModified Date
I2C-bus specification and user manual (REV 6.0) PDF (1.4 MB) UM1020428 Apr 2014
I2C-bus specification and user manual (REV 5.0) PDF (1.6 MB) UM10204_JA03 Apr 2013
PCA9600 demonstration board OM6293 (REV 1.0) PDF (130.0 kB) UM1032315 Dec 2008
I2C Demonstration Board 2005-1 Quick Start Guide (REV 1.0) PDF (261.0 kB) UM1020613 Jun 2006
Brochures (3)
Name/DescriptionModified Date
NXP® I2C-bus solutions 2014: Smart, simple solutions for the 12 most common design concerns (REV 1.0) PDF (3.5 MB) 7501754001 Aug 2014
I2C/SMBus buffers for backplane multi-point and hot-swap applications; NXP® Level-shifting and... (REV 1.0) PDF (773.0 kB) 7501653001 Jul 2008
Extend the I2C-bus with advanced repeaters and hubs; NXP® 2-channel I2C-bus repeaters PCA9515x and... (REV 1.0) PDF (740.0 kB) 7501653201 Jul 2008
Package Information (3)
Name/DescriptionModified Date
HWSON8: plastic thermal enhanced very very thin small outline package, no leads; 8 terminals; (REV 1.1) PDF (190.0 kB) SOT1069-210 Jun 2016
plastic thin shrink small outline package; 8 leads; body width 3 mm (REV 1.0) PDF (240.0 kB) SOT505-108 Feb 2016
plastic small outline package; 8 leads; body width 3.9 mm (REV 1.0) PDF (244.0 kB) SOT96-108 Feb 2016
Packing (3)
Name/DescriptionModified Date
HWSON8; Reel pack, SMD, 7" Q2/T3 Turned 90 degree product orientation Orderable part number ending, 147 or... (REV 1.0) PDF (196.0 kB) SOT1069-2_14706 May 2014
SO8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or J Ordering... (REV 2.0) PDF (232.0 kB) SOT96-1_11819 Apr 2013
TSSOP8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or... (REV 1.0) PDF (214.0 kB) SOT505-1_11815 Apr 2013
Supporting Information (4)
Name/DescriptionModified Date
Reflow Soldering Profile (REV 1.0) PDF (34.0 kB) REFLOW_SOLDERING_PROFILE30 Sep 2013
Wave Soldering Profile (REV 1.0) PDF (20.0 kB) WAVE_SOLDERING_PROFILE30 Sep 2013
Footprint for reflow soldering (REV 1.0) PDF (9.0 kB) SO-SOJ-REFLOW08 Oct 2009
Footprint for wave soldering (REV 1.0) PDF (8.0 kB) SO-SOJ-WAVE08 Oct 2009
IBIS Model
Ordering Information
ProductStatus
PCA9517ATPActive
PCA9517ADPActive
PCA9517ADActive
Package Information
Product IDPackage DescriptionOutline VersionReflow/Wave SolderingPackingProduct StatusPart NumberOrdering code(12NC)MarkingChemical ContentRoHS / Pb Free / RHFLeadFree Conversion DateEFRIFR(FIT)MTBF(hour)MSLMSL LF
PCA9517ATPSOT1069-2Reel 7" Q2/T3ActivePCA9517ATP,147 (9352 977 14147)17APCA9517ATPAlways Pb-free0.02.05E811
PCA9517ADSOT96-1SO-SOJ-REFLOW SO-SOJ-WAVE
SO-SOJ-REFLOW SO-SOJ-WAVE
Reel 13" Q1/T1ActivePCA9517AD,118 (9352 857 63118)PA9517APCA9517ADAlways Pb-free0.02.05E811
Bulk PackActivePCA9517AD,112 (9352 857 63112)PA9517APCA9517ADAlways Pb-free0.02.05E811
PCA9517ADPSOT505-1Reflow_Soldering_ProfileReel 13" Q1/T1ActivePCA9517ADP,118 (9352 857 64118)9517APCA9517ADPAlways Pb-free0.02.05E811
PCA9517ADP/DGSOT505-1Reflow_Soldering_ProfileReel 13" Q1/T1WithdrawnPCA9517ADP/DG,118 (9352 869 38118)9517AAlways Pb-free0.02.05E811
Level translating I2C-bus repeater pca9517atp
Level shifting techniques in I2C-bus design pca9685pw
I2C / SMBus Repeaters, Hubs and Expanders pca9600
I2C-bus specification and user manual pca9685pw
I2C-bus specification and user manual pca9685pw
PCA9600 demonstration board OM6293 pca9600
I2C Demonstration Board 2005-1 Quick Start Guide pca9685pw
NXP® I2C-bus solutions 2014: Smart, simple solutions for the 12 most common design concerns pca9685pw
I2C/SMBus buffers for backplane multi-point and hot-swap applications; NXP® Level-shifting and... pca9518apw
Extend the I2C-bus with advanced repeaters and hubs; NXP® 2-channel I2C-bus repeaters PCA9515x and... pca9600
Reflow_Soldering_Profile Wave_Soldering_Profile LPC1112FD20
PCA9517A IBIS model PCA9517AD
PCA9517ADP IBIS model PCA9517ADP
HWSON8: plastic thermal enhanced very very thin small outline package, no leads; 8 terminals; PCT2075TP
HWSON8; Reel pack, SMD, 7" Q2/T3 Turned 90 degree product orientation Orderable part number ending, 147 or... PCT2075TP
plastic small outline package; 8 leads; body width 3.9 mm CBT3306_Q100
Footprint for reflow soldering NPIC6C596A_Q100
Footprint for wave soldering NPIC6C596A_Q100
SO8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or J Ordering... CBT3306_Q100
plastic thin shrink small outline package; 8 leads; body width 3 mm pesd5v0l7bas
Reflow_Soldering_Profile Wave_Soldering_Profile LPC1112FD20
TSSOP8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or... pesd5v0l7bas
PCA9517ADP
PCT2075
SA612A
PCT2075