The PCA9519 is a 4-channel level translating I²C-bus/SMBus repeater that enables the processor low voltage 2-wire serial bus to interface with standard I²C-bus or SMBus I/O. While retaining all the operating modes and features of the I²C-bus system during the level shifts, it also permits extension of the I²C-bus by providing bidirectional buffering for both the data (SDA) and the clock (SCL) lines, thus enabling the I²C-bus or SMBus maximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins are over-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
The port B drivers are compliant with SMBus I/O levels, while port A uses a current sensing mechanism to detect the input or output LOW signal which prevents bus lock-up. The port A uses a 1 mA current source for pull-up and a 200 Ω pull-down driver. This results in a LOW on port A accommodating smaller voltage swings. The output pull-down on the port A internal buffer LOW is set for approximately 0.2 V, while the input threshold of the internal buffer is set about 50 mV lower than that of the output voltage LOW. When the port A I/O is driven LOW internally, the LOW is not recognized as a LOW by the input. This prevents a lock-up condition from occurring. The output pull-down on the port B drives a hard LOW and the input level is set at 0.3 of SMBus or I²C-bus voltage level which enables port B to connect to any other I²C-bus device or buffer.
The PCA9519 drivers are not enabled unless VCC(A) is above 0.8 V and VCC(B) is above 2.5 V. The enable (EN) pin can also be used to turn the drivers on and off under system control. Caution should be observed to only change the state of the EN pin when the bus is idle.
0 Hz to 400 kHz clock frequency
Name/Description | Modified Date |
---|---|
4-channel level translating I2C-bus/SMBus repeater (REV 3.0) PDF (178.0 kB) PCA9519 | 10 Jan 2013 |
Name/Description | Modified Date |
---|---|
Level shifting techniques in I2C-bus design (REV 1.0) PDF (52.0 kB) AN10441 | 20 Jun 2007 |
I2C / SMBus Repeaters, Hubs and Expanders (REV 2.0) PDF (1.0 MB) AN255 | 19 Dec 2002 |
Name/Description | Modified Date |
---|---|
I2C-bus specification and user manual (REV 6.0) PDF (1.4 MB) UM10204 | 28 Apr 2014 |
I2C-bus specification and user manual (REV 5.0) PDF (1.6 MB) UM10204_JA | 03 Apr 2013 |
PCA9600 demonstration board OM6293 (REV 1.0) PDF (130.0 kB) UM10323 | 15 Dec 2008 |
I2C Demonstration Board 2005-1 Quick Start Guide (REV 1.0) PDF (261.0 kB) UM10206 | 13 Jun 2006 |
Name/Description | Modified Date |
---|---|
NXP® I2C-bus solutions 2014: Smart, simple solutions for the 12 most common design concerns (REV 1.0) PDF (3.5 MB) 75017540 | 01 Aug 2014 |
Extend the I2C-bus with advanced repeaters and hubs; NXP® 2-channel I2C-bus repeaters PCA9515x and... (REV 1.0) PDF (740.0 kB) 75016532 | 01 Jul 2008 |
Name/Description | Modified Date |
---|---|
plastic thermal enhanced very thin quad flat package; no leads; 24 terminals; body 4 x 4 x 0.85 mm (REV 1.0) PDF (202.0 kB) SOT616-1 | 08 Feb 2016 |
Name/Description | Modified Date |
---|---|
HVQFN24; reel pack; standard product orientation; 12NC ending 118 (REV 1.0) PDF (196.0 kB) SOT616-1_118 | 16 Jan 2014 |
Product | Status | Package version | Application | Enable | Function | Operating Temperature (Cel) | Number of bits | Voltage Translation Range (V) | Operating voltage (VDC) | Operating voltage 2 (V) | Inputs | Outputs | TTL Drive (mA) | GTL Drive (mA) | I2C-bus (kHz) |
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
PCA9519BS | Active | SOT616-1 | -40~85 | 3.0~5.5 | 0.9~5.5 | 4 | 4 | 400 |
Product ID | Package Description | Outline Version | Reflow/Wave Soldering | Packing | Product Status | Part NumberOrdering code(12NC) | Marking | Chemical Content | RoHS / Pb Free / RHF | LeadFree Conversion Date | EFR | IFR(FIT) | MTBF(hour) | MSL | MSL LF |
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
PCA9519BS | SOT616-1 | Reel 13" Q1/T1 | Active | PCA9519BS,118 (9352 812 52118) | 9519 | PCA9519BS | Always Pb-free | 0.0 | 2.0 | 5E8 | 1 | 1 |