System PMIC for Battery Powered Systems - BD71815GW

BD71815GW is a single-chip power management IC for battery-powered portable devices. The IC integrates 5 buck converters, 8 LDOs, a boost driver for LED, and a 500mA single-cell linear charger. Also included is a Coulomb counter, a real-time clock (RTC), a 32kHz crystal oscillator and a general-purpose output (GPO).The IC’s buck converters supply power to the application processor as well as system peripherals such as DDR memory, wireless modules, and touch controllers. These regulators maintain high efficiency over a wide range of current loads by supporting both PFM and PWM modes. They also operate at a high switching frequency of 6MHz, which allows the use of smaller and cheaper inductors and capacitors. The regulator supplying the processor core also supports Dynamic Voltage Scaling(DVS).You can download the product information.→ (PDF: 0.8MB), (PDF: 2.3MB) Reference Board - For software and/or system development, Embedded Artists's System on Module (SOM) can be used with one of its application-specific carrier boards, as a standard EVK or hardware development platform. EA's i.MX7 SOM integrates i.MX 7Dual processor, BD71815GW PMIC, 8 GB of flash and 1GB LP-DDR3 in a compact 27 mm x 37 mm PCB. , BD71815GW

Part NumberStatusPackageUnit QuantityMinimum Package QuantityPacking TypeRoHS
BD71815GW-E2ActiveUCSP55M4C25002500TapingYes
Specifications
GradeStandard
Vin1(Min.)[V]3.5
Vin1(Max.)[V]28.0
SW frequency(Max.)[MHz]6.0
Channel(DCDC)[ch]5
Channel(LDO)[ch]3
Operating Temperature (Min.)[°C]-40
Operating Temperature (Max.)[°C]85
Technical Documents
Features
  • 5 buck converters:
  • 3 general-purpose LDOs
  • LDO for DDR Reference Voltage (DVREF)
  • LDO for Secure Non-Volatile Storage (SNVS)
  • LDO for Low-Power State Retention (LPSR)
  • LDO for SD Card with dedicated enable terminal
  • LDO for SD Card Interface with dedicated terminal
    to dynamically change output voltage
  • White LED Boost Converter
  • Single-cell Linear LIB Charger with 30V OVP
  • Voltage Measurement for Thermistor
  • Embedded Coulomb Counter for Battery Fuel Gauging
  • Battery Monitoring and Alarm Output
  • Real Time Clock with 32.768kHz crystal oscillator
  • 1 GPO Open Drain or CMOS Output Selectable)
  • Power Control I/O
  • 1 LED Indicator
  • I2C interface
Related Product
PART NUMBERProduct SeriesDatasheet
BD9528AMUVBuck Converters (Synchronous & Controller)Datasheet
BD9528AMUV2 Channel Output Switching RegulatorsDatasheet
BD4271FP2-CLDO Regulators with Watch-Dog TimerDatasheet
BD42530EFJ-CVoltage TrackersDatasheet
BD42530FP2-CVoltage TrackersDatasheet
BD37201NUXSingle-Output LDO RegulatorsDatasheet
BD9528AMUV BD9528AMUV
BD4271HFP-C BD4271HFP-C
BD42530FP2-C BD42530FP2-C
BD37201NUX BD37201NUX
Application Note BA12004BF
Part Explanation BA12004BF