AAT1274 1.5A Single Flash LED Driver IC
The AAT1274 is a high-efficiency, high-current boost converter capable of 1.5A typical output current. It is an ideal power solution for LED photo flash applications in all single cell Li-ion powered products. The AAT1274 maintains output current regulation by switching the internal high-side and low-side switch transistors. The transistor switches are pulse-width modulated at a fixed frequency of 2MHz. The high switching frequency allows the use of a small inductor and output capacitor, making the AAT1274 ideally suited for small battery-powered applications. Skyworks' proprietary AS2Cwire™ (Advanced Simple Serial Control™) serial digital interface is used to enable, disable, configure, and program the operation of the AAT1274. Using the AS2Cwire interface, the movie-mode current level for each LED, the safety timer delay, and the flash-to-movie-mode current ratio can be programmed to one of 16 levels. In addition, the single-wire serial protocol sets output channel control. The AAT1274 also includes a separate Flash Enable input to initiate both the flash operation and the default timer which can be used either to terminate a flash event at the end of a userprogrammed delay or as a safety feature. Also included is a Flash Inhibit pin which reduces the flash current to movie-mode levels during high battery demand. The maximum flash and movie-mode current is set by one external resistor where the ratio of Flash to Moviemode current is set at approximately 7.3:1. One or two LEDs can be connected to the AAT1274, where in the case of two LEDs the output current is matched between each diode. The AAT1274 contains a thermal management system to protect the device in the event of an output short-circuit condition. Built-in circuitry prevents excessive inrush current during start-up. The shutdown feature reduces quiescent current to less than 1.0μA. The AAT1274 is available in a Pb-free, thermally-enhanced 14-pin 3x3mm TDFN package.
技术特性
- VIN Range: 2.7V to 5.5V
- Dual Channel Output
- Up to 1.5A Regulated Output Current (750mA per
channel)
- Up to 85% Efficiency with Small Inductor (1μH)
- 2 MHz Switching Frequency
- Separate Flash Enable
- User-Programmable Safety Timer
- Single Resistor Sets Flash and Movie Mode Current
- Two Wire, I2C Compliant Serial Interface
- Fast, 400kHz Serial Transfer Rate
- 16 Level Movie-mode Current
- Flash/Movie-mode
- Current Output Channel Control
- Safety Timer
- True Load Disconnect
- nput Current Limit
- Over-Voltage (Open LED, Open Circuit), Short Circuit,
and Over-Temperature Protection
- Shutdown Current < 1.0μA
- 14-pin TDFN 3x3 mm Package
- 40°C to +85°C Temperature Range
|
应用领域 APPLICATION
- Camcorder Video Light (Torch Light)
- Cellphones/Smartphones
- Digital Still Cameras (DSCs)
- LED Photo Flash/Torch
- Mobile Handsets
订购信息 Ordering Information
AAT1274 典型应用
|