Part Number | Data Sheet | SPICE Model | Qualified to AECQ10x | PPAP Capable | Topologies (Buck) | Topologies (Buck-Boost) | Topologies (Boost) | MinimumInput Voltage (V) | MaximumInput Voltage (V) | Maximum Output Voltage (V) | Maximum LED Current (A) | LED Current Accuracy (%) | Switching Frequency Maximum (kHz) | Dimming (PWM) | Dimming (Analog) | Efficiency (%) | OperatingTemperatureRange (°C) | Sense Voltage (mV) | AEC-Q100 Grade |
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
PAM2861 | PAM2861.pdf | - | - | - | Yes | - | - | 6 | 40 | 40 | 1 | 5 | 1000 | Yes | Yes | 97 | -40 to +85 | 100 | - |
The PAM2861 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected °Cs efficiently from a voltage source higher than the °C voltage. The device operates from an input supply between 6V and 40V and provides an externally adjustable output current of up to 1A. Depending upon supply voltage and external components, this can provide up to 30 watts of output power. The PAM2861 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted below the set value, by applying an external control signal to the VSET pin. The VSET pin will accept either a DC voltage or a PWM waveform. The soft-start time can be increased using an external capacitor from the VSET pin to ground. Applying a voltage of 0.2V or lower to the VSET pin turns the output off and switches the device into a low current standby state.