• 简体中文
• English

DS9503：ESD保护二极管，带有电阻

This DS9503 is an ESD protection device for 1-Wire® interfaces. In contrast to the DS9502, the DS9503 includes two 5Ω isolation resistors on chip. Although 5Ω are negligible during communication, they represent a high impedance relative to the conducting diode during an ESD event. Thus, the diode absorbs the energy while the resistors further isolate and protect the circuit at the other side of the package. If used with circuits that already have a strong ESD-protection at their I/O port, the ESD protection level is raised to more than 27kV (IEC 801-2 Reference model). In case of abnormal ESD hits beyond its maximum ratings the DS9503 will eventually fail "short" thus preventing further damage. During normal operation the DS9503 behaves like a Zener diode. When the voltage exceeds the trigger voltage, the I/V characteristic of the device will "snapback" allowing the same or higher amount of current to flow, but at a significantly lower voltage. As long as a minimum current or voltage is maintained, the device will stay in the "snapback mode." If the voltage or the current falls below the holding voltage or holding current, the device will abruptly change to its normal mode and conduct only a small leakage current.

关键特性 Zener characteristic with voltage snap-back to protect against ESD hits High avalanche voltage, low leakage and low capacitance avoid signal attenuation Compatible to all 5V logic families Space-saving, low-inductance TSOC surface-mount package On-chip 5 ohm resistors for isolation at both anode and cathode terminals Industrial temperature range

DS9503：典型应用电路

数据手册DataSheet

关键参数

技术资料

• Lightning Bolts, Defibrillators, and Protection Circuitry Save Lives

质量和环境数据

• DS9503.pdf

订购型号