• 简体中文
• English

MAX3097E：±15kV ESD保护、32Mbps、3V/5V、三路RS-422/RS-485接收器，带有故障检测

The MAX3097E/MAX3098E feature three high-speed RS-485/RS-422 receivers with fault-detection circuitry and fault-status outputs. The receivers' inputs have fault thresholds that detect when the part is not in a valid state. The MAX3097E/MAX3098E indicate when a receiver input is in an open-circuit condition, short-circuit condition, or outside the common-mode range. They also generate a fault indication when the differential input voltage goes below a preset threshold. See Ordering Information or the Electrical Characteristics in the full data sheet for threshold values. The fault circuitry includes a capacitor-programmable delay to ensure that there are no erroneous fault conditions even at slow edge rates. Each receiver is capable of accepting data at rates up to 32Mbps.

关键特性 Detects the Following RS-485 Faults: Open-Circuit Condition Short-Circuit Condition Low Differential Voltage Signal Common-Mode Range Violation ESD Protection ±15kV—Human Body Model ±15kV—IEC 1000-4-2, Air-Gap Discharge Method ±8kV—IEC 1000-4-2, Contact Discharge Method Single +3V to +5.5V Operation -10V to +13.2V Extended Common-Mode Range Capacitor-Programmable Delay of Fault Indication Allows Error-Free Operation at Slow Data Rates Independent and Universal Fault Outputs 32Mbps Data Rate 16-Pin QSOP is 40% Smaller than Industry-Standard 26LS31/32 Solutions

MAX3097E、MAX3098E：典型应用电路 应用 嵌入式系统 高速、三路RS-485/RS-422接收器，具有增强型ESD保护功能 用于电机轴编码器的RS-485/RS-422接收器 电信 具有输入故障指示的三路RS-485/RS-422接收器

数据手册DataSheet

关键参数

质量和环境数据

• MAX3097E.pdf

订购型号