• 简体中文
• English

MAX5911：-48V、Simple Swapper热插拔开关

-48V热插拔开关，适用于IP电话和通过同一电缆传输数据、电源的数据终端设备

The MAX5911/MAX5912 are fully integrated hot-swap switches for negative supply rails. These devices allow the safe insertion and removal of circuit cards into live backplanes or ports without causing problematic glitches on the negative power-supply rail. They also monitor various circuit parameters and disconnect the load if a fault condition occurs, alerting the host with a logic-level FAULT-bar output. The MAX5911/MAX5912 operate over a voltage range of -16V to -65V and are designed to permit hot plugging of an IP phone into a hub, but are not limited to that operation. During startup, an internal power FET regulates the current between the backplane power source and the load to 280mA for MAX5911 and 415mA for MAX5912. After startup, the FET is fully enhanced to reduce its on-resistance. To ensure robust operation, the MAX5911/MAX5912 contain built-in safety features that prevent damage to the internal FET. They include an enable input, which responds to positive logic signals (+3.3V or +5V), allowing the host system to disconnect the load. ENABLE is also used to reset the device after a latching fault condition occurs. The MAX5911/MAX5912 Simple Swapper™ hot-swap ICs monitor four parameters for these fault conditions: undervoltage lockout (UVLO), power-not-good, zero-current detection, and thermal shutdown. These devices are available in the extended temperature range, -40°C to +85°C. The MAX5911 and MAX5912 come in 8-pin and 16-pin SOIC packages, respectively.

关键特性 Provides Safe Hot Swap for -16V to -65V Power Supplies 280mA Current Limit for MAX5911 415mA Current Limit for MAX5912 Zero-Current Load Disconnect Integrated Power FET Status Output Reports Fault Condition Internal Switch-Protection Circuitry Built-In Thermal Shutdown DGND Can Vary Up to ±5V with Respect to AGND

MAX5911、MAX5912：典型工作电路 应用 桥路 网络集线器、交换机和路由器 路由器/交换机

数据手册DataSheet

关键参数

开发工具

• MAX5911EVKIT

订购型号