• 简体中文
• English

ST6G3244ME：Level translator for SD, SDIO, mini SD, micro SD cards with internal I/O supply and 15kV ESD protection

The ST6G3244ME is a dual supply, low voltage 6-bit bi-directional CMOS level translator for SD, mini SD and micro SD Cards. Designed for use as an interface between baseband and memory cards, it achieves high speed operation while maintaining CMOS low-power dissipation.

The A-port is designed to track V_CCA. The internal LDO is powered by V_BATand provides a power supply of either 1.8 V or 2.9 V to the B-side I/Os (programmed by the SEL pin). The B-port is designed to track V_CCB. The V_CCBvoltage can be also used externally. When V_CCB= 0 V, there is no additional leakage seen on V_CCA. All outputs are push-pull type.

This device is intended for two-way asynchronous communication between data buses. The direction of data transmission is determined by CMD.dir, DAT0.dir and DAT123.dir inputs.

All inputs are equipped with protection circuits against electrostatic discharge, giving them ±2 kV (on A-side) and ±15 kV (on B-side, CD and WP) ESD and transient excess voltage immunity.

Key Features

• Supports 60 MHz clock rate
• Supports DDR mode for SD Card™
• Compliant with
  • SD Specification Part 1 Physical Layer Specification 3.00 (SDR12, SDR25, DDR50)
  • SD Specification Part 1 Physical Layer Specification 2.00
• Bi-directional with direction control pin
• Balanced propagation delays: tPLH ≈ tPHL
• LDO power-down support. When the LDO is powered down, VCCB is pulled to GND via the 130 Ω resistor. When VCCB = 0 V, there is no additional leakage seen on VCCA .
• EMI filtering and signal conditioning
• Supports both 1.8 V and 2.9 V data translation on card side
• Integrated LDO to supply 1.8 V or 2.9 V power for B-side I/Os (pin-selectable); can be used also externally
• Integrated pull-up and pull-down resistors on B-side
• Operating voltage range
  • VCCA = 1.62 V to 1.98 V
  • VBAT = 3.0 V to 5.0 V
• Latch-up performance exceeds 100 mA (JEDEC Standard 78)
• ESD protection for card side (B-port, CD and WP pins)
  • ±8 kV contact discharge (IEC61000-4-2)
  • ±15 kV air-gap discharge (IEC61000-4-2)
• ESD protection for host side (A-side)
  • ±2 kV HBM (JEDEC 22-A114)
  • ±200 V MM (JEDEC 22-A115)
• Operating temperature range –40 °C to +85 °C
• Space-saving Flip Chip 25 package (2 x 2 x 0.605 mm, 0.4 mm bump pitch)
• RoHS compliant, lead-free soldering capable

产品规格

手册

样片和购买

质量和可靠性