ZXLD1360：Medium Voltage DC-DC LED Drivers
| Part Number | Data Sheet | SPICE Model | Qualified to AECQ10x | PPAP Capable | Topologies (Buck) | Topologies (Buck-Boost) | Topologies (Boost) | MinimumInput Voltage (V) | MaximumInput Voltage (V) | Maximum Output Voltage (V) | Maximum LED Current (A) | LED Current Accuracy (%) | Switching Frequency Maximum (kHz) | Dimming (PWM) | Dimming (Analog) | Efficiency (%) | OperatingTemperatureRange (°C) | Sense Voltage (mV) | AEC-Q100 Grade |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ZXLD1360 | ZXLD1360.pdf | - | - | - | Yes | - | - | 7 | 30 | 30 | 1 | 5 | 1000 | Yes | Yes | 95 | -40 to +125 | 100 | 1 |
Description
The ZXLD1360 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected °Cs efficiently from a voltage source higher than the °C voltage. The device operates from an input supply between 7V and 30V and provides an externally adjustable output current of up to 1A. Depending upon supply voltage and external components, this can provide up to 24 watts of output power. The ZXLD1360 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted above, or below the set value, by applying an external control signal to the 'ADJ' pin. The ADJ pin will accept either a DC voltage or a PWM waveform. Depending upon the control frequency, this will provide either a continuous or a gated output current. The PWM filter components are contained within the chip. The PWM filter provides a soft-start feature by controlling the rise of input/output current. The soft-start time can be increased using an external capacitor from the ADJ pin to ground. Applying a voltage of 0.2V or lower to the ADJ pin turns the output off and switches the device into a low current standby state.
Application
- Low voltage halogen replacement LEDs
- Automotive lighting
- Low voltage industrial lighting
- LED back-up lighting
- Illuminated signs
Features
- Simple low parts count
- Internal 30V NDMOS switch
- 1A output current
- Single pin on/off and brightness control using DC voltage or PWM
- Internal PWM filter
- Soft-start
- High efficiency (up to 95%)
- Wide input voltage range: 7V to 30V
- 40V transient capability
- Output shutdown
- Up to 1MHz switching frequency
- Inherent open-circuit °C protection
- Typical 4% output current accuracy
Ordering Information
- ZXLD1360ET5TA
- ZXLD1360EV8
TSOT25
- ZXLD1360.pdf ZXLD1360
