• 简体中文
• English

MAX3158：High CMRR RS-485 Transceiver with ±60V Isolation

The MAX3158 is a high CMRR RS-485/RS-422 data-communications interface providing ±60V isolation in a hybrid microcircuit. A single +5V supply on the logic side powers both sides of the interface, with external 100V capacitors transferring power from the logic side to the isolated side. Each MAX3158 contains one transmitter and one receiver and is guaranteed to operate at data rates up to 250kbps. Drivers are short-circuit current limited and protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high receiver output if the inputs are open, shorted, or connected to a terminated transmission line with all drivers disabled. The MAX3158 typically draws 25mA of supply current when unloaded or when fully loaded with the driver disabled. Supply current drops to 25µA when the device is placed in shutdown mode. The device is pin selectable between half- and full-duplex mode and also features an independently programmable receiver and transmitter output phase through separate pins. The MAX3158 is a low-cost replacement for opto-isolated transceivers. For fully isolated RS-485/RS-422 transceivers, refer to the MAX1480 family data sheet.

Key Features ±60V Isolated Data Interface +5V Single Supply Low-Cost Replacement for Opto-Isolated Transceivers True Fail-Safe Receiver While Maintaining EIA/TIA-485 Compliance Pin-Selectable Full/Half-Duplex Operation Phase Controls to Correct for Twisted-Pair Reversal 25µA Low-Power Shutdown Mode Thermal Shutdown for Driver Overload Protection 28-Pin SSOP Package Slew-Rate-Limited Reduced EMI

MAX3158: Typical Operating Circuit Applications/Uses Industrial Controls Level Translators Local Area Networks (LANs) Telecommunications

DataSheet

Parametrics

Ordering Information