• 简体中文
• English

MAX5924：1V to 13.2V, n-Channel Hot-Swap Controllers Require No Sense Resistor

The MAX5924/MAX5925/MAX5926 1V to 13.2V hot-swap controllers allow the safe insertion and removal of circuit cards into live backplanes. These devices hot swap supplies ranging from 1V to 13.2V provided that the device supply voltage, VCC, is at or above 2.25V and the hot-swapped supply, VS, does not exceed VCC. The MAX5924/MAX5925/MAX5926 hot-swap controllers limit the inrush current to the load and provide a circuit-breaker function for overcurrent protection. The devices operate with or without a sense resistor. When operating without a sense resistor, load-probing circuitry ensures a short circuit is not present during startup, then gradually turns on the external MOSFET. After the load probing is complete, on-chip comparators provide overcurrent protection by monitoring the voltage drop across the external MOSFET on-resistance. In the event of a fault condition, the load is disconnected. The devises include many integrated features that reduce component count and design time, including configurable turn-on voltage, slew rate, and circuit-breaker threshold. An on-board charge pump provides the gate drive for a low-cost, external n-channel MOSFET. The MAX5924/MAX5925/MAX5926 are available with open-drain PGOOD and/or active-low PGOOD outputs. The MAX5925/MAX5926 also feature a circuit breaker with temperature-compensated RDS(ON) sensing. The MAX5926 features a selectable 0ppm/°C or 3300ppm/°C temperature coefficient. The MAX5924 temperature coefficient is 0ppm/°C and the MAX5925 temperature coefficient is 3300ppm/°C. Autoretry and latched fault-management configurations are available (see the Selector Guide in the full data sheet).

Key Features Hot Swap 1V to 13.2V with VCC > 2.25V Drive High-Side n-Channel MOSFET Operation With or Without RSENSE Temperature-Compensated RDS(ON) Sensing Protected During Turn-On into Shorted Load Adjustable Circuit-Breaker Threshold Programmable Slew-Rate Control Programmable Turn-On Voltage Autoretry or Latched Fault Management 10-Pin µMAX® or 16-Pin QSOP Packages

MAX5924, MAX5925, MAX5926: Functional Diagram Applications/Uses Base Stations Network Routers and Switches Portable Device Bays RAID Remote-Access Servers Servers

DataSheet

Parametrics

Design kits & evaluation modules

• MAX5926EVKIT

Quality and Environmental Data

• MAX5924.pdf

Related Products

• MAX4272：3V to 12V, Current-Limiting, Hot Swap Controllers with Autoretry, DualSpeed/BiLevel Fault Protection
• MAX4271：3V to 12V, Current-Limiting, Hot Swap Controllers with Autoretry, DualSpeed/BiLevel Fault Protection

Ordering Information