• 简体中文
• English

MAX97000：Audio Subsystem with Mono Class D Speaker and Class H Headphone Amplifier

Industry's Smallest 2mm x 2mm 25-Bump WLP Audio Subsystem with Limiter, Best Class D and H Class Headphone Amplifier

The MAX97000 audio subsystem combines a mono speaker amplifier with a stereo headphone amplifier and an analog DPST switch. The headphone and speaker amplifiers have independent volume control and on/off control. The four inputs are configurable as two differential inputs or four single-ended inputs. The entire subsystem is designed for maximum efficiency. The high-efficiency 725mW Class D speaker amplifier operates directly from the battery and consumes no more than 1µA in shutdown mode. The Class H headphone amplifier utilizes a dual-mode charge pump to maximize efficiency while outputting a ground-referenced signal that does not require output coupling capacitors. The speaker amplifier incorporates a distortion limiter to automatically reduce the volume level when excessive clipping occurs. This allows high gain for low-levels signals without compromising the quality of large signals. All control is performed using the 2-wire, I²C interface. The MAX97000 operate in the extended -40°C to +85°C temperature range, and is available in the 2mm x 2mm, 25-bump WLP package (0.4mm pitch).

Key Features 1.6V to 2.0V Headphone Supply Voltage 2.7V to 5.5V Speaker Supply Voltage Internal LDO Allows Single-Supply Operation 725mW Speaker Output (VPVDD = 3.7V, ZSPK = 8Ω + 68µH) 40mW/Channel Headphone Output (RHP = 16Ω) Low-Emission Class D Amplifier Efficient Class H Headphone Amplifier Ground-Referenced Headphone Outputs Two Stereo Single-Ended/Mono Differential Inputs Integrated Distortion Limiter (Speaker Outputs) Integrated DPST Analog Switch No Clicks and Pops TDMA Noise Free 2mm x 2mm, 25-Bump 0.4mm Pitch WLP Package

MAX97000: Simplified Block Diagram Applications/Uses Cell Phones Portable Multimedia Players

DataSheet

Parametrics

Design kits & evaluation modules

• MAX97000EVKIT

Ordering Information