AM26LV32E-EP 增强型产品低电压高速四路差动线路驱动器，具有 +/-15-kV IEC ESD 保护
The AM26LV32E-EP is a quadruple differential line driver with 3-state outputs. This driver has ±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge) protection. This device is designed to meet TIA/EIA-422-B and ITU Recommendation V.11 drivers with reduced supply voltage.
The device is optimized for balanced-bus transmission at switching rates up to 32 MHz. The outputs have high current capability for driving balanced lines, such as twisted-pair transmission lines, and provide a high impedance in the power-off condition.
The AM26LV32E-EPI is characterized for operation from –40°C to 85°C
| AM26LV32E-EP | |
| Receivers Per Package | 4 |
| Supply Voltage(s)(V) | 3.3 |
| Supply Voltage(s)(Min)(V) | 3 |
| Supply Voltage(s)(Max)(V) | 3.6 |
| ESD(kV) | 15 |
| Signaling Rate(Mbps) | 32 |
| Temp Range(C) | -55 to 125 |
| Rating | HiRel Enhanced Product |
| Operating Temperature Range(�C) | -55 to 125 |
| # of TX/RX | 0 TX / 4 RX |
| Pin/Package | 16SOIC |
AM26LV32E-EP 特性
- Meets or Exceeds Standard TIA/EIA-422-B and ITU Recommendation V.11
- Operates From a Single 3.3-V Power Supply
- ESD Protection for RS422 Bus Pins
- ±15-kV Human-Body Model (HBM)
- ±8-kV IEC61000-4-2, Contact Discharge
- ±15-kV IEC61000-4-2, Air-Gap Discharge
- Switching Rates up to 32 MHz
- Low Power Dissipation: 27 mW Typ
- Open-Circuit, Short-Circuit, and Terminated Fail-Safe
- ±7-V Common-Mode Input Voltage Range With ±200-mV Sensitivity
- Accepts 5-V Logic Inputs With 3.3-V Supply (Enable Inputs)
- Input Hysteresis: 35 mV Typ
- Pin-to-Pin Compatible With AM26C32, AM26LS32
- Ioff Supports Partial-Power-Down Mode Operation
- SUPPORTS DEFENSE, AEROSPACE, AND MEDICAL APPLICATIONS
- Controlled Baseline
- One Assembly/Test Site
- One Fabrication Site
- Available in Military (–55°C/125°C) Temperature Range(1)
- Extended Product Life Cycle
AM26LV32E-EP 芯片订购指南
| 器件 | 状态 | 温度 | 价格 | 封装 | 引脚 | 封装数量 | 封装载体 | 丝印标记 |
| AM26LV32EMDREP | ACTIVE | -55 to 125 | 1.86 | 100u | SOIC (D) | 16 | 2500 | LARGE T&R | |
| V62/09602-01XE | ACTIVE | -55 to 125 | 1.86 | 100u | SOIC (D) | 16 | 2500 | LARGE T&R |
AM26LV32E-EP 质量与无铅数据
| 器件 | 环保计划* | 铅/焊球涂层 | MSL 等级/回流焊峰 | 环保信息与无铅 (Pb-free) | DPPM / MTBF / FIT 率 |
| AM26LV32EMDREP | Green (RoHS & no Sb/Br) | CU NIPDAU | Level-1-260C-UNLIM | AM26LV32EMDREP | AM26LV32EMDREP |
| V62/09602-01XE | Green (RoHS & no Sb/Br) | CU NIPDAU | Level-1-260C-UNLIM | V62/09602-01XE | V62/09602-01XE |
AM26LV32E-EP 应用技术支持与电子电路设计开发资源下载
- AM26LV32E-EP 数据资料 dataSheet 下载.PDF
- TI 德州仪器RS-422选型与价格 . xls
- 所选封装材料的热学和电学性质 (PDF 645 KB)
- 使用数字隔离器设计隔离式 I2C 总线接口 (zhct119.PDF, 339 KB)
- 1Q 2011 Issue Analog Applications Journal (slyt399.PDF, 964 KB)
- 接口选择指南 (Rev. D) (PDF 2994 KB)
- Signaling Rate vs. Distance for Differential Buffers (PDF 420 KB)
- Q1 2009 Issue Analog Applications Journal (slyt319.PDF, 1.39 MB)
- Isolated RS-485 Reference Design (PDF 80 KB)
- 无铅组件涂层的保存期评估 (PDF 1305 KB)
- Analog Signal Chain Guide (8.62 MB)
- Industrial Interface IC Solutions (101 KB)
